4×5 Film Holders
Film holders are an important part of a good 4x5 view camera system. Without them it is impossible to properly expose your film. Most 4x5 film holders are designed to hold two pieces of film (one on either side) in a completely light tight manner until positioned in the camera back and readied for exposure. Make sure to find good quality film holders, otherwise you could be frustratingly searching for that light leak that keeps showing up on all your negatives.
 |
 Film Back Holder 612 6x12 for large format 4x5 camera  US $179.00
|
 4x5 no 23 graflex roll holder for graflox back US $45.00
|
 no 22 graflex 120 roll holder for 4x5 graphic cameras US $45.00
|
 graflex rh 10 120 roll holder for 4x5 graphic cameras US $45.00
|
 Collection of 24 film holders for 4x5 camera US $60.00
|
 GRAFLEX GRAFMATIC 4X5 FILM HOLDER US $15.50
|
 Pair of Locking Riteway 4x5 Cut Film Holders Used US $29.95 |
 fujifilm quickload film holder 4x5 US $49.99
|
 Vintage Large Format camera 4x5 Kodak film pak holder US $8.85
|
 polaroid 545 land film holder for 4x5 02 US $14.99
|
 polaroid 545 land film holder for 4x5 01 US $19.99
|
 Lot of 12 Film Holders 4 x 5 Fidelity Lisco Graflex US $49.95
|
 Vtg Polaroid 545 4X5 Film Holder w Box Inst Complete US $19.99
|
 4x5 cut sheet film holders lisco regal II set of 3 US $14.99
|
 4x5 sheet film holders NO DARK SLIDES lisco regal II US $.99
|
 Lot of 5 Fidelity Elite 4x5 Film Holders US $48.00
|
 4x5 sheet film holder DARK SLIDE US $3.00
|
 4x Lisco Regal II 4x5 film holder US $50.00
|
 Fidelity 4x5 Sheet Film Holders Twin Pack BRAND NEW US $51.00
|
 Fidelity Elite 4x5 Film Holder Large Format US $5.00
|
4x5 film holders should be designed to allow you to firmly but smoothly pull out the cover when you’re ready to make your exposure. If they are too tight you could end up knocking your camera off subject while trying to remove it. Just as bad, if they are too loose they could fall out or be unintentionally pulled out before you were ready, exposing and ruining your sheet of film.
